Instructions

Bike On The Ledge #2 mounting instructions:

Select a section of a load bearing/masonry wall (not hollow or gypsum)
Before drilling or putting a screw into a wall, be sure you've checked what's behind it with a pipe, cable and stud detector
Place the bike hanger against the wall where you would like it mounted using a spirit level
Keeping the hanger against the wall (with the spirit level) place your hand inside the hanger and mark the screw holes on the wall with a pen
Remove the hanger to check the three screw holes are marked correctly on the wall
Using amasonry drill bit (the width of the plugs provided), drill three holes where you've marked on the wall. Make sure to drill perpendicularly into the wall
Insert the plugs into the three holes
Place the bike hanger back into position against the wall and using a screw driver, screw the screws tightly into the plugs
Lift your bike onto the hanger and decorate to match your home. Now step back and enjoy your new work of art!

Bike On The Ledge #3 mounting instructions:

Select a section of a load bearing/masonry wall (not hollow or gypsum)
Before drilling or putting a screw into a wall, be sure you've checked what's behind it with a pipe, cable and stud detector.
Find the two points under your bike's frame where you'd like the poles positioned
Mark these two points on the wall using a spirit level
Using amasonry drill bit (the width of the plugs provided), drill two holes where you've marked on the wall. Make sure to drill perpendicularly into the wall.
Insert the plugs into the two holes
Screw the poles tightly into the plugs in the wall. Some strength in required
Lift your bike onto the hanger and enojy!

sufBoard On The Ledge mounting instructions:

Select a section of a load bearing/masonry wall (not hollow or gypsum)
Before drilling or putting a screw into a wall, be sure you've checked what's behind it with a pipe, cable and stud detector
Choose the position on the wall where you'd like to place the hangers under your surfboard (depending on the length of your board)
Holding each hanger to the wall, use a spirit level to make sure the hangers are level and mark the screw holes with a screw or thin screwdriver that fit through the holes in the hanger
Remove the hangers from the wall and drill where the markings are
With a masonry drill bit (the width of the plugs provided), drill all holes
Once all holes have been drilled, insert the plugs into the holes
Align the hanger with the holes in the wall, then place the small wooden bracket (provided) horizontally over the hole
Place the screws in the holes, then using a screwdriver gently screw the screws into the hanger until tight
Hide the screw holes with the adhesive cork provided
Place the remaining adhesive cork on the hanger where the board rests
Now place your surfboard on the hanger and enoy!

BOTL #1 Natural Oil & Smoked | Instruction video